Primarily responsible for performing rework/repair to comply with J-STD-001/IPC-7711 & 7721
standards. Understands the hand soldering process and able to make good judgment concerning
good and bad solder joints. Uses care in the operation of soldering irons, other hand tools, and
understands safety issues related to hand soldering in the workplace.
Must be able to solder to J-STD-001 Class II and III
Must be able to perform rework/repair to IPC 7711 & 7721 standards
Must be able to perform repetitive assembly tasks with accuracy and dexterity
Must be able to read and interpret industry standards, engineering drawings and specifications
Must have basic computer proficiency
A high school diploma/equivalent with minimum 5 years rework soldering experience to J-STD001 Class II and III / IPC-7711 & 7721.
Essential Job Functions:
Solders to IPC-610/620 and J-STD-001 workmanship criteria (Class II & Class III)
Solders electronic components/wires to circuit board
Perform rework to IPC-7711 & 7721 standards
Adjust or trim materials or hardware to achieve specified electrical or dimensional characteristics
Assembles small wires to and/or screw in hardware to circuit board assemblies
Participates in company or special training classes with emphasis on employee improvement
Ensures work area is kept clean and safety rules are followed
Perform other reasonable duties as assigned
D052 7/18/19 2
Essential skills and experience:
Ability to orally communicate well with management/peers
Ability to identify components and component values
Ability to follow work instructions
Ability to follow direction from management
Solders to J-STD-001 Class II and III
Reworks to IPC-7711 & 7721
Ability to work well independently and within a team
Ability to learn through shadowing and following documented procedures
Commitment to company values
Strong computer proficiency: ability to learn and use ERP system
Experience soldering fine-pitched parts preferred
Nonessential skills and experience:
Working knowledge of ISO 9001, AS9100, ISO 13485
Current IPC-610/J-STD certification
Reporting to this position: No direct reports
Physical demands and work environment:
Physical demands: while performing the duties of this job, employee is required to walk, sit, use
computer and may interact with employees. Sitting most shift with use of soldering iron, solder,
flux and other necessary chemicals/tools for soldering. May be required to lift up to 5 pounds. May
lift trays or push carts of PCB assemblies from one department to another.
Work environment: while performing the duties of this job, employee will be in a manufacturing
floor setting under fluorescent lighting and company radio.
Standard shift M-F from 7:00am – 3:30pm.
Able to work OT when needed.
- Contract Specialties Group is an Equal Opportunity Employer. We consider applicants without regard to race, color, religion, age, national origin, ancestry, ethnicity, gender, gender identity, gender expression, sexual orientation, marital status, veteran status, disability, genetic information, or membership in any other group protected by federal, state or local law.
Job ID: 17879